2"(50mm) – 2-1/2"(63mm) Installation Instructions

< Back to Previous Page

Installation Guidelines
1. Transair pipe and hoses: Transair pipe should be protected from mechanical impact, particularly if exposed to collision with fork-lift trucks or when sited in an environment with moving overhead loads. Similarly, rotation of the pipe and pipe supports should be avoided. Transair pipe must not be welded.

2. Expansion and contraction: Expansion and contraction of the system should be calculated prior to installation. The system designer and installer should calculate the elongation or retraction of each Transair line according to the recommendations in this installation guide.

3. Situation to avoid: Installation within a solid mass (concrete, foam, etc.), the hanging of any external equipment to Transair pipe, the use of Transair for grounding or as a support for electrical equipment, and exposure to chemicals that are incompatible.

4. When assembling Transair connectors, do not interchange the nuts with different Transair bodies due to our calibration process.


2"(50mm) – 2-1/2"(63mm) Installation Instructions
Tools
Click Here for the Tools Page
pipe cutter tool Pipe cutter for aluminum pipe
ref. 6698 03 01
chamfer tool Chamfer tool for aluminum pipe
ref. 6698 04 01
deburring tool Deburring tool for aluminum pipe
ref. 6698 04 02
drilling jig Drilling jig for aluminum pipe
ref. 6698 01 03
drilling tool Drilling tool for aluminum pipe
ref. 6698 02 01
drill Drill
Procedure
1. Cutting the pipe:
place the pipe in the pipe cutter position the blade onto the pipe rotate the pipe cutter around the pipe while gently tightening the wheel.
2. Carefully chamfer the outer edges.
3. Deburr the inner end of the pipe.
4. Drill the two clamp holes using the drilling jig (6698 01 03) and the 1" drilling tool (6698 02 01).
Loosen the jig, release the pipe, then deburr both holes. Ensure that all outer and inner surfaces are smooth and clear of burrs and potential sharp edges.

Connection
1. Unscrew one of the connector nuts and fit over the pipe
2. Position the double clamp ring in the appropriate housings (two holes at the end of the pipe)
3. Bring the nut towards the body, which were previously positioned at the end of the pipe, until it stops against the double clamp
4. Tighten the nut by hand
5. Bring the two pipes together
6. Complete the assembly by 1/2 rotation with Transair tightening spanners (ref. 6698 05 03)

Disconnection
To disconnect, perform the same operations in reverse order

Lateral Dismantling
1. Loosen the connector nuts on the ends of the pipe to be removed
2. Slide them along the pipe
3. Remove the snap rings from their housings
4. Slide the clamps and the connector body along the pipe which is to be removed
5. Repeat the operation at the other end of the pipe and laterally remove the pipe, complete with the assembly components


Back to Main Training Page
  Email this Page 

Also Available from mdi

Powerex Oil-less
Air Compressors
Finite Filters
powerexsales.com
Coxreels
Hose Reels
Coxreels Hose Reels
coxreelsales.com
Drain-All
Condensate Drains
Coxreels Hose Reels
drainallsales.com
mdi
   
 TransairAluminumPipe.com is owned and operated by mdi, Manufacturers Distributor, Inc. mdi is an Authorized Parker Transair Piping System Distributor. Click Here to view the mdi Line Sheet.